Half Off Locksmith technician and service van

Home | Cities | Hollywood

Rekey Service in Hollywood

Rekeying changes which key operates a lock without replacing the lock itself. This page is general guidance for people in Hollywood who are thinking about it, with the questions worth asking before anyone starts work.

Call (954) 888-8804

What actually happens inside a rekeyed lock

A standard pin tumbler lock has a brass cylinder, called the plug, that turns when the right key lifts a row of small pins to exactly the right heights. Those pins sit in pairs, and the gap between each pair has to line up with the edge of the plug for the cylinder to rotate. When you rekey, the technician removes the plug, replaces the pins with a different combination, and cuts new keys to match. The old key still enters the keyway, but it no longer lifts the pins correctly, so it cannot turn anything.

The lock body, the latch, the handle and the finish all stay where they are. That is why rekeying is often described as a change of the secret rather than a change of the hardware. You end up with the same deadbolt on the same door, and the only visible difference is a new key in your hand. Nothing about the way the door looks or feels should change, which suits people who like their existing hardware.

Because only the pins and keys are being changed, the lock has to be in reasonable mechanical shape to begin with. A cylinder that already sticks, grinds or needs a jiggle to turn will not be fixed by new pins. A good technician will tell you that before starting, so that you can decide whether the better move is a rekey, a repair of the worn part, or a new lock. You can read a longer walkthrough in the guide on how rekeying a lock works.

The moments when people call about it

The most common trigger is a move. When you take over a house or a condo, you have no way of knowing how many copies of the old keys exist. Previous owners, tenants, relatives, cleaners, contractors and agents may all have held one at some point. Most of those people mean no harm, but you cannot account for them, and a rekey turns an unknown number of keys into a known number. There is more detail in the article on rekeying locks after moving.

The second trigger is a lost or stolen key. If a key goes missing along with something that identifies where it belongs, such as a wallet with an address card, the sensible response is to change the lock rather than hope. The same goes for a key handed to someone who has since left your life, whether that was a roommate, a partner, a former employee or a house sitter. Think of it as closing a door on the past rather than admitting a failure.

The third trigger is simply wanting less hardware on the keyring. Many households end up with a front door key, a back door key, a garage entry key and a mailbox key, all different. Rekeying several locks to one key is a tidy fix, and it is one of the more pleasant reasons to make the call. People who have just finished a renovation or a repaint often take that moment to simplify as well.

Rekey, replace or upgrade: how to decide

Rekeying wins when the locks are sound and you like them. It costs less effort than replacement, keeps the door looking the same, and the work happens at the door without drilling or reshaping anything. If the hardware is solid, matches the rest of the house and turns smoothly, a rekey is usually the right answer. The comparison is covered in the guide to rekeying versus replacing locks.

Replacement makes more sense when a lock is physically failing, when it is a very low grade product, or when the finish has pitted and the handle wobbles. South Florida humidity and salt air are hard on exterior hardware, and a lock that has corroded inside is better retired than rekeyed. Replacement is also the moment to consider a stronger grade of deadbolt, a longer strike plate screw, or a different style of handle that suits the house.

An upgrade is its own category. If you have been thinking about a keypad or a smart lock, the time you are already paying for a locksmith visit is a good time to ask about it. You can read about the trade offs in the pages on smart locks and on lock installation in Hollywood. A smart lock still has a mechanical key backup in many models, so even then you may want that cylinder rekeyed.

What a rekey will not fix

A rekey changes who can turn the cylinder. It does nothing for a door that is easy to kick in, a frame that has split near the strike plate, or a gap between door and jamb that lets a tool slip in. Many break ins happen at a weak frame rather than a weak cylinder, so it is worth looking at the door as a whole when you are already thinking about security. A short strike plate held by short screws is a very common weak point, and it can be fixed separately.

It also does not repair a door that will not latch. If the bolt scrapes the strike, or the door has to be lifted to close, the cause is usually alignment, swelling from humidity, or hinge wear. The guide on doors that will not latch explains what is usually behind it. Tell the locksmith about the symptom, because rekeying a lock on a door that rubs the frame will only give you a new key for a door that still misbehaves.

Finally, a rekey does not change the digital side of anything. If your front door has a keypad with a code, the code is separate from the key cylinder, and you will want to change the code on your own whenever people who knew it no longer need it. Treat the physical key and the code as two different secrets that need separate housekeeping, and handle each one on its own schedule.

Condos, rentals and older homes

Broward housing comes in a wide mix of types, and each one brings its own questions. Condos, rentals, single family homes and townhouses all behave a little differently when it comes to who decides what happens at the front door, so it helps to know which one you are dealing with before you pick up the phone. This page is general guidance, not a statement of local rules. In a condo, the entry door to your unit may fall under association rules, and some buildings keep a master or emergency key on file. Requirements vary from building to building, so ask your management office what they permit before work begins. Do not assume you can change a lock and keep it a secret from the people who are meant to know.

In a rental, the answer depends on the lease and on local rules, which no general page can settle for you. If you are a tenant, ask your landlord before changing anything. If you are a landlord, turnover is the natural moment to change keys between tenants, and the guides on rekeying rental property and on tenant turnover cover how people usually approach it.

Older homes often have a mix of lock brands installed over decades, with doors that have been painted shut and hardware that has been repaired more than once. Rekeying is still possible on many of them, but it can take a closer look first, because older cylinders may have worn keyways or parts that are no longer common. A technician who looks at the lock before promising anything is doing you a favor. Newer builds tend to have uniform hardware, which makes it easier to bring several doors onto one key.

Salt air, humidity and the life of a cylinder

Coastal air carries moisture and fine salt, and both find their way into exterior locks. Over a few seasons that shows up as keys that feel gritty, cylinders that turn only after a few tries, or a latch that stiffens in the wet months. Rekeying is a decent time to notice this, because the plug is out of the lock and the technician can see what condition the insides are in. If the interior is dry and clean, fine. If it is rusty or crusted, that is a reason to talk about replacing the cylinder.

A word on lubricant, because people mean well here. Heavy oil or general purpose sprays tend to attract dust and sand and can gum up pins over time. A dry graphite or a lubricant intended for locks is the usual choice, and you should ask the technician what they recommend for your particular hardware. Less is more, and a lock that has been over sprayed is often harder to rekey cleanly than one left alone.

Hurricane season adds another habit worth building. Before a storm, people tend to think about shutters and supplies, and rarely about spare keys. If you may need to leave on short notice, or if someone will be minding your house while you are away, make sure everybody has a working key. After a storm, check that exterior doors still close and latch properly, since swollen frames and shifted hinges can change how a bolt lines up with its strike.

Putting several doors on one key

Keyed alike is the term for locks that all open with the same key. For a house, it means one key for the front door, the back door and the garage entry, which is a relief when your hands are full of groceries. The locksmith rekeys each cylinder to a shared pin pattern, then cuts keys that fit that pattern. It goes most smoothly when the locks are from the same family of keyways, though adapters and replacement cylinders can bridge gaps when they are not.

There are trade offs. One key for everything means that losing it affects every door at once. For many families that is acceptable because the convenience is worth it, but a few prefer to keep a separate key for a workshop, a storage closet or a home office. There is no single right answer, and it is fair to ask for a mix, such as one key for the main entrances and a different one for an inside room.

If you are managing a small business or a property with several units, the idea scales into a master key system, where each door has its own key and one higher level key opens them all. That is a bigger design question and deserves its own conversation. The articles on keyed alike and master key systems and on commercial locksmith work are a good place to start.

What to say when you call

A short, specific description helps the person on the phone more than a long story. Say what kind of property you have, which doors you want done, how many keys you want when the work is finished, and whether the locks currently work smoothly. If you know the brand of the lock, mention it, and if you can see a name stamped on the latch edge or the inside face, that helps too. Photos are not required, but a clear description of what you see will do.

Mention anything unusual. A deadbolt that sticks, a handle that has been replaced by someone before you, a lock with no visible brand, a door that is old and heavy, or a gate that shares a key with the house are all details that change the plan. If you are renting or in a condo, say so, and say whether you have permission. Honesty at this stage keeps the visit smooth. It also helps to have the keys you currently use in your hand when you call, because the keyway shape stamped on the key head and the way the teeth are cut tell a technician a good deal before anyone arrives. If you have a spare that has never been used, set it aside and keep it with you, since it will be useful for comparison.

Before work starts, the process is simple. The work and the price are explained to you first, you agree, the locks are rekeyed, and the finished result is tested with you at the door. Asking questions is normal and expected. For a few pointers on what is reasonable to ask, the guide to questions to ask a locksmith on the phone is worth a read.

After the work: habits that keep it effective

A new set of keys is only as private as the people who hold them. Keep a list, even a mental one, of who has a copy, and think twice before duplicating keys at a self service kiosk. Duplicates made from duplicates drift slightly in cut depth, and a worn copy can start to wear the pins inside the lock. If you need extras, have them cut from the original or by a locksmith from the code, and read the notes in the article on where and how to duplicate keys.

Test every key before the technician leaves, and try each one a few times. Turn the lock from the outside and from the inside, with the door open and with it closed, so the bolt can extend fully into the strike. If anything feels rough, say so right then. It is much easier to have a small adjustment made while someone is still standing at your door.

Finally, pick a calm moment to think about how often to repeat this. Many households rekey when circumstances change rather than on a schedule. A change of residents, a spell of contractors in the house, or a lost key are the usual reasons. The guide on how often to rekey a home goes through the thinking, and the overview on house lockouts and rekeying pulls together the related services.

Common questions

Will my old key still work after a rekey?

No. The point of rekeying is that the pins inside the cylinder are changed to a new pattern, so the old key may slide into the keyway but cannot lift the pins correctly and will not turn the lock. That is why the work is useful after a move, a lost key, or a change in who lives or works at the property.

Do I need to replace the whole lock to change the key?

Not usually. If the lock is in good mechanical shape, the cylinder can be rekeyed and the same hardware stays on the door. Replacement becomes the better choice when the lock is worn, corroded, damaged or too low in quality to trust, or when you want a different style or stronger grade.

Can several doors be set to open with one key?

Yes, in many cases. Each cylinder is rekeyed to a shared pattern so one key operates them all. Compatibility depends on the keyway and brand, and sometimes a cylinder has to be swapped to make a door join the group. A technician can tell you after looking at the locks in question.

Is a rekey enough to improve security?

It solves the problem of unknown keys, but it does not strengthen a weak door, a short strike plate or a loose frame. If your concern is forced entry rather than copied keys, ask the locksmith to look at the door and frame as well, and consider whether an upgraded deadbolt or reinforced strike makes sense.

Can I rekey a lock in a rental or condo?

Possibly, but requirements vary. Tenants usually need the landlord's agreement, and many condo buildings have rules about entry doors or keep an emergency key on file. Check your lease and ask your management office or association before work begins, then tell the locksmith what you were told.

What should I do if a lock feels stiff before rekeying?

Mention it when you call. Stiffness can come from salt, grit, worn pins, a misaligned door or a failing latch, and each has a different remedy. A rekey will not cure a sticking lock by itself, so the technician may suggest a repair or replacement of the cylinder before or instead of rekeying.

Talk through the job before work begins

Tell us what happened, which doors or keys are involved and who needs to get in. The price and the plan are agreed with you before any work starts.

Call (954) 888-8804

Related pages

Call Now